Aqua Oil 100

Product Information

The mains-powered or battery-powered interceptor alarm system with a single probe sensor is installed within the separator to automatically detect the levels of oil, silt and liquid within. If excessive levels are reached, the alarm activates a klaxon or beacon to provide an audible or visual notification of excessive liquid levels.

Alarm warnings allow you time to take corrective action ensuring the safe and economic operation of separators, preventing oil from passing through the separator and polluting watercourses which may result in expensive fines and clean-up costs.

The alarm system and sensors guarantee an increased level of safety and require simple installation for bespoke monitoring of oil and petrol separators.

We can tailor your separator alarm to your requirements by displaying your name and contact details on the liquid crystal display and fitting your custom label (please ask for details).

Specification

• Mains Control Panel (230v)
• Battery-Powered Control Panel
• Oil Probe with 5m flylead
• Enclosure: IP66/67
• Dimensions: 180 x 130 x 60mm
• Input: Single input to monitor float or conductivity oil probe
• Audible warning: beeper sounds when oil or air is detected
• ATEX for intrinsic safety as associated apparatus according to BS EN 60079-11
• Specific Marking of Explosion Protection: Ex II (1) G [Ex ia Ga] IIB (-20°C ≤ Ta ≤ +50°C)

Benefits

• Warn of excessive levels of oil, liquid and silt
• Tells you when the separator needs emptying
• Reduces waste management costs
• Designed to comply with EN858-1&2 and PPG3
• Can be fitted to interceptors from all manufacturers
• Reduces interceptor servicing costs
• Automated and remote monitoring
• Ensures safe and economic operation of interceptors

Installation, Commission and Service

Within the contracted service visit, we will be undertaking the following:

Interceptor Alarm(s)

• Assessing the circuit board(s), and related components, to sustain maximum efficiency
• Confirming all groundworks and cabling around the unit is in sufficient order
• Confirming the unit (if solar powered) if holding a voltage
• Checking and recording battery strength (if solar-powered)
• Confirming the cabinet has not been damaged or vandalised and is in good working order
• Cleaning and Re-calibration of all probes used within the unit
• Re-commissioning of equipment after inspection and providing certification to comply with the required health and safety / environmental guidelines.

All the above steps are vital for any company to meet the Environmental Agencies Guidelines (PPG3) for efficient pollution prevention control and to enable your equipment to function correctly.